11/10/2023 0 Comments Labeled measuring tape![]() These stud designations are intended to indicate the "on-center" position of framing members. This shows you the length of your tape measures housing. You will find a measurement listed there. You will rarely use these markings unless you happen to be building a shed or playhouse, or constructing partition walls during major remodeling projects. Take a look at the side of your tape measure, near the belt clip. These increments correspond to the common intervals for the studs, joists, and rafters that are used to create the basic structural framework for walls, floors, and roofs. Find the Stud Markingsįor the benefit of framing carpenters who do repetitive work, most tape measures also have convenient markings at 16-inch and 19.2-inch increments, usually designated by a number highlighted in red, or by a small diamond marking on the blade. 1/16- and 1/32-inch increments are more often used in fine woodworking projects where hardwood workpieces need to fit very tightly. When framing walls, for example, tolerances down to 1/8-inch are usually completely sufficient to bang studs and joists into place. On dual-purpose tape measures, the numerals on the opposite side of the blade indicate centimeters.įor general construction work using framing lumber, it's usually sufficient to measure down to 1/8-inch increments.On some tape measures, the inch markings repeat 1- to 12-inch increments on one side of the blade, with running inch increments on the other side (as shown here).Inch marks are usually in the largest font.At 8 feet, for example, you will see both a "8 ft." and a "96" inch designation. Inch mark numbering usually continues along the entire length of the blade. The next increments of measure on a tape measure blade are the inch marks, which will be identified by the longest lines and usually labeled with a single numeral-1, 2, 3, etc. The 100-foot length is usually made of cloth and is useful for survey and determining property boundaries. Builders commonly use the 25-foot length, while the 12-foot length is the most common length used by consumers. It's the same thing, but a little easier to read on the tape and remember. Most of the tape measures in circulation today are 12 foot, 25 foot, or 100 foot. So, instead of a ceiling being measured as 7 feet, 6 inches, it would be measured as 90 inches. That way, you only need to pay attention to one set of figures: inches. ![]() The Spruce Home Improvement Review Boardįoot marks are valuable, but often it's easier to avoid them altogether and measure only in terms of inches.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |